Home Farmhouse Sinks Installation of The Farmhouse Sink

Installation of The Farmhouse Sink

386
Installation Farmhouse Sink
Image Via : .debkadas.com

The installation farmhouse sink is usually done by skilled contractors or workers.  If you think you have the expertise then you should be able to do it yourself.   However , to ensure a high standard of  workmanship be sure to engage professional help to install your farmhouse sink.

Consider the Sink’s Weight

Take into account also the sink’s weight : most kitchen sinks drop into a hole cut in the top of the countertop and are supported by  the base cabinets and the countertop.  Understand the weight of an apron-front sink can reach several hundred pounds when   filled with water. Your base cabinet must be of a  material strong enough for support to be installed that can accommodate that weight.  Most manufacturers list the  weight of the apron-front sink.   To figure the added weight when filled with water, multiply the number of gallons the sink holds by 8.34 pounds (weight of one gallon of water).  The base cabinet will need to be modified with supports to hold at least this amount of weight.

Take measurements and Add Supports

Once you have determined your  base cabinet can be modified to accommodate the sink’s weight, it’s time to take some measurements.  Having the sink on hand will make this much easier.  Begin by measuring the width of the sink.  Next, determine if you need to cut the existing countertop for the sink to fit.  This is especially important if your countertop is made of stone, where special cutting may be required.  Now measure the height of the sink.  Use this measurement on the interior of the base cabinet to mark where the supports will go.  Use a level line from the back to the front.  Then attach three supports, two across the sides and one across the back.  Make sure your supports can hold the required weight and are securely fastened to the base cabinet.

Install the Floor

You can now install the floor. First, measure the distance between the side supports.  Now measure the depth of the farmhouse sink.  Next, use these measurements to cut the floorboard. After that, select a plywood with the thickness strong enough to accommodate the sink’s weight.  If the plywood is too thin, it can crack.  Lastly, install the floorboard by screwing it to the supports.

Cut the Cabinet Front and Doors

To cut the front of the cabinet, measure the sink and mark the area to be cut out.  A jigsaw can be used to make the cut. First of all, placing painters tape along the edge of the cut mark will protect the cabinet.  In order to hide the plywood floorboard, a top rail can be cut.  Take note that your cabinet doors will also need to be cut to fit between the new top rail and the bottom rail.

– Apron-Front Sinks – Installation Farmhouse Sink

SOURCEdoityourself.com
SHARE